How To Install a Garage Door The first step to installing a new garage door is removing the old door, using the instructions provided by the door manufacturer, carefully remove the old door, this consists mainly carefully unlatching the door from the pulley system, then the panels of the door are taken apart and then unscrewing the tracks, care should be taken so that the panels do not fall on you by making sure only one panel is removed at a time the door opening height and width, the headroom from the top opening of the ceiling, and the back room measurements are taken, upon measurement, stops are attached to both sides of the opening, they are made sure that they flush with the door jamb’s inside edge, using the sawhorses the bottom piece of the new door is laid out, weather stripping may be attached, hinges are then attached and handles lifted to piece the bottom piece is then inserted into the door frame using a level in order to set it properly, having set the piece in place, the tap nails partway into each jamb, the nails should be bent slightly or slant to secure them in place, the vertical, curved and horizontal pieces of the track are then assembled using manufacturer’s instructions and the set aside the second panel is installed on top of the first panel, before installing the hinges, the nails are hammered into the side jambs to make sure they are well held in place, this process is repeated depending on the number of panels, each of the pieces should be anchored into the door jamb, this is the fourth step when installing a new garage door
What No One Knows About Repairs
upon securing all sections, rollers are installed in the section that supports the rollers, upon completion, the rollers are then placed in the pre-assembled track, the tracks brackets are secured in the process, it is a precaution measure not to press the rollers too tightly against the track, this is because the friction that may result is harmful
The Key Elements of Great Doors
when the vertical tracks are well secured against the jambs, installation of the curved and horizontal pieces takes place, the previous measurements are used when installing the horizontal pieces, the tracks should be levelled in order to make sure they are straight and they should point 90 degrees away from the opening, according to the manufacturer’s instructions springs are then assembled, when attaching the springs to the pulley, the door is lifted to half length and then pulled up the remaining distance, that is basically how to install a garage door